Description
Around ANTHBOT, comparisons are strikingly common: Genie 1000 vs M9, Genie 600 vs M5, M5 vs Genie 3000. That may be relevant for the purchase decision—when it comes to the spare part, it disappears. All six models use the same mowing disc: Genie 600, 1000, 3000 as well as M5, M9 and M5 LiDAR. Optionally available with seven or nine pre-assembled stainless steel blades.
Six models, one disc
ANTHBOT runs the Genie series and the M-Series in parallel. They differ in navigation, mowing area performance, and equipment – but for the cutting system, the manufacturer has chosen a shared base.
This is a real advantage for owners. If you drive a Genie 1000 today and switch to an M9 later, you can continue using existing replacement parts. Even the blades are interchangeable between all models.
For us, that means we stock a single disc for the entire brand—and keep it in stock permanently instead of ordering it individually.
Compatible ANTHBOT models
Genie or M series?
This comparison is one of the most frequently asked questions about the brand—here’s the answer from a spare parts perspective:
Replacement on the ANTHBOT
- Switch the device off and remove it from the charging station.
- Put on gloves and lay the robot on its side.
- Remove clippings around the mounting area.
- Loosen the old cutting disc, fit the new one, and tighten evenly.
- Finally, tap each blade plate— it must be able to rotate freely around its screw.
For the LiDAR models, it’s worth taking a look at the scanner on the top afterward. If it’s covered in grass splashes, navigation becomes less precise—and the robot drives more meters than necessary.
Technical data
| Blade count | 7 or 9 blades (selectable) |
| Blade material | Stainless steel |
| Blade storage | Freely rotating on the screw – folds away when encountering obstacles |
| Mowing disc material | Impact-resistant plastic composite |
| Compatible with | Genie 600, 1000, 3000, M5, M9, M5 LiDAR |
| Package contents | 1 mowing disc with factory-mounted blades |
| Installation | Direct replacement of the original cutting disc |
| Shipping | Ships directly from the manufacturer within the EU, dispatch within 24 h |
7 or 9 blades
Both blade configurations fit all six ANTHBOT models. The deciding factors are how often the robot drives and how short the lawn is kept.
7 blades – for regular operation
The right configuration for gardens that the robot handles several times per week. Seven cutting edges provide a clean mowing pattern without the load being distributed across too many narrow edges.
Where growth is more vigorous or accumulates more between drives, this is the more robust option.
9 blades – for daily use
The densest blade setup is worth it when the ANTHBOT is out and about nearly every day and only trims the tips. Then even individual blades of grass that remain standing disappear as well, which would otherwise be left over due to wider mowing paths.
With larger mowing intervals, the advantage is reversed: the same amount of work is spread across more edges, which therefore become dull earlier.
For owners of the LiDAR version, an additional thought: If you mow close to the edges, you should check the cutting edges regularly—most notches form there.
When it’s time to replace
Buy blades individually
Because ANTHBOT replacement parts are hard to find in stores, having a supply of blades is part of the basic equipment here. The 60-blade replacement set including screws fits all six models of the brand and is enough for many replacements.